MN Plumbing Repair | Faucet and Pipe Repair MN

Plumbing Repair MN | Repair Dripping Faucets and Leaky Toilets

The Environmental Protection Agency (EPA) estimates that 11,000 gallons of water are wasted each year from running toilets, dripping faucets and other plumbing leaks in the home. Most of these leaks are easily fixed and could save you hundreds of dollars on your water bill. A certified plumber has the knowledge and skills to troubleshoot and fix any leaks in your home.

The Facts on Leaks:

• Did you know that, in a year, water leaks in your home can waste enough water to fill a backyard swimming pool? And if we added up all the water leaking in people’s homes right now it could fill a trillion gallons of milk jugs? That’s enough water for all the people living in the cities Los Angeles, Chicago, and Miami combined.
• Water-wasting leaks include running toilets, dripping faucets, and other leaking pipes around your home. Most of these leaks can be fixed easily.
• Fixing these leaks can save more than 10 percent on water bills. That’s like saving $1 for every $10 spent on water.

Finding Leaks

• Find the water meter on your house. Usually, it’s on the outside of the house in a box or under a metal cover on the sidewalk that says “Water.” The numbers in the box represent either gallons or cubic feet of water used in your home. Check your meter, then don’t flush the toilet, run the faucet, or use any water for two hours. At the end of the two hours, check the water meter again. If the meter does not read exactly the same, you probably have a leak.
• Walk through your house listening for running toilets and looking for drips.  Drips usually mean leaks.
• Find out if your toilet is leaking silently by placing a drop of food coloring in the toilet tank (that’s the area behind the toilet seat.  If color shows up in the toilet bowl after 15 minutes without flushing, you have a leak. Once you finish the experiment, flush a few times so you don’t stain the toilet.

Fix a Leak!

Faucets:

• Take a watch or clock with a second hand and time how often your faucet drips.  A leaky faucet that drips at the rate of one drip per second can waste more than 3,000 gallons in a year!
• There are parts that hold your faucet together called washers and gaskets—they can wear down and cause drips. If someone in your house is handy, these parts usually can be replaced easily.
• There’s also a little screen device called an “aerator” that can be screwed onto the tip of your faucet—it adds air into the water stream so you can use less water to wash your hands or brush your teeth without noticing a difference in water flow.
Look for the WaterSense label when buying an aerator or replacing a faucet—that means the product will work well and save water.

Showers:

• Showerheads—the place where water comes out in streams at the top of your shower—can also get old and leak, even when the water is not on. A showerhead that drops just 10 drips in a minute wastes more than 500 gallons per year. That’s enough water, if you saved it all up, to wash 60 loads of dishes in your dishwasher!
• Most leaky showerheads can be fixed by making sure they’re screwed in tight. Having someone handy wrap the showerhead in “pipe tape,” a special tape available at hardware stores, and using a wrench to tighten it will help.

Toilets:

• It’s one of the oldest prank phone calls—“Is your toilet running? Then you’d better catch it!” But a running toilet is no joke. If you can hear the water in your toilet making noise, even when no one flushed recently, you have a running toilet that could be wasting 200 gallons of water or more every day!  Sometimes you just need to jiggle the handle to fix it, but sometimes a part needs to be replaced.
• Many toilets leaks are caused because the “flapper” is decayed or broken. The flapper is a rubber piece that opens up to let the water flow from the tank into the bowl when you pull down on the toilet handle. If someone in your house is handy, they can easily replace this inexpensive part of your toilet.
• If the problem is not just an old flapper and you have to replace a leaky toilet, look for one with the WaterSense label to save both water and money on your water and sewer bill.

Outdoors:

• Check your garden hose for leaks where it connects to the side of the house. If it leaks when the hose is turned on, make sure the hose is screwed in tight. If that doesn’t work, someone handy may need to replace the nylon or rubber hose washer or wrap the “spigot,” which is the metal faucet where the end of the hose attaches to the wall, in pipe tape.
• If you have a sprinkler system that waters your lawn, check the system each spring before turning it on to make sure the sprinklers were not broken during the winter or have sprung any leaks.

There are other ways to conserve water, too. If you’re building a new home or remodeling your kitchen or bathroom, you’ll save by installing tankless water heaters, low-flow plumbing fixtures, dual-flush toilets.

Fix Leaks Now!

While some leaks may be easy to spot, others require the expertise of a certified plumber. It is a good idea to have a plumber make routine checks on your plumbing system. Annual maintenance will ensure that any issues are found quickly before the problem gets worse.

So when the faucet is leaking, or the drain is clogged, or the water heater is not producing hot water, making repairs now will save you big bucks not only water, but future plumbing repairs.  Contact a Minnesota Plumber who can give you more expert tips on keeping the plumbing in your home running smoothly and efficiently!

They will be happy to offer maintenance suggestions that will avoid these problems in the future, extend the life of your plumbing system and maybe even save you some money on your energy bills!

Leave a Reply